Buy Sunuv SUN 8 lamp wholesale and retail in ubeauty.pro store

SUNUV makes sure that their products satisfy as many users as possible. That is why lamps of various sizes are produced: both large enough (which are only suitable for stationary use) and small enough (which you can take with you on trips, vacations, to work on the road, etc.). The SUN 8 lamp, for example, is 2 times smaller and lighter than the SUN 3 lamp, and therefore in some cases it will be more convenient. However, the best part is that only the design and dimensions of the lamps change, while their high technical characteristics and convenient functionality remain the same.

The SUNUV SUN 8 lamp is a more miniature model compared to all the others. Not only does it weigh just 550g, but it also measures 225x138x85mm (LxWxH). Thanks to this, it is perfect for artists working on the road, as well as for users who want to do their own manicure / pedicure.

Despite the diminutive size of the lamp, there will be enough space under it for both the hand when performing a manicure and and for a foot during a pedicure.

The lamp has 21 hybrid LEDs built into the lamp, each of which emits both LED and UV light. This technology significantly expands the variety of nail materials with which the master can work, and all because the range of the ultraviolet spectrum has become wider.

The LEDs on the inside of the body are arranged in an arc, that is, in such a way that the light hits directly on the nail plates of each finger, but this is only possible with the correct position of the hand under the lamp. Such an arrangement of the LEDs guarantees a high quality of polymerization, and therefore a long wear of the nail material on the nails.

The power of the LEDs is 48 W in general timer modes, that is, at 30 and 60 seconds. But when you select a timer for 99 seconds, a gentle mode is activated, in which the power drops to 24 watts. With such a ratio of time and power, the polymerization process is much slower, but it is also "easier", since burning nails can most often be avoided. Initially, the power of the LEDs is minimal, after 30 seconds it increases slightly, and after 50 it reaches its maximum value. But at the last stage of polymerization, the burning sensation should not occur at all.

For the timer modes, you can set the memory mode for 30 and 60 seconds. This is done quite quickly - with one click on the timer button for 2-3 seconds. Thus, with each subsequent position of the hand under the LEDs, the mode that was "remembered" earlier will automatically turn on. You can turn off the memory mode by double-clicking on any of the buttons.

If none of the modes was selected before the start of polymerization, then when you place your hand under the LEDs, the infinity mode is automatically activated, that is, the mode with a timer of 120 seconds .

Motion sensors are located on the inside of the lamp on both sides. The master will not need to constantly press the button to start polymerization - the LEDs will turn on automatically.

The lamp has no bottom at all, and this is what makes it so light and small. But on the other hand, it has a display for monitoring the polymerization time.

The features of the lamp can also include the presence of a protective system: when the LEDs are very hot, the lamp automatically turns off to avoid overheating and burnout.

The average life of the SUN 8 lamp is 50,000 hours of continuous use, which is almost 6 years of daily use. So its durability and reliability are guaranteed, even if you work on the road and have to carry the lamp in your bag all the time.