Buy Saeyang Marathon N7/S40 Milling Machine wholesale and retail in ubeauty.pro store

To produce a hardware manicure/pedicure with convenience and a minimal likelihood of problems is the desire of any nail service master. But not every router and handle will be able to satisfy this desire, because if the cutter works stably when performing a manicure, then when performing a pedicure, it can slow down or even stop. The thing is that a manicure is performed at a medium or high speed of rotation of the nozzle, and a pedicure is performed at a low speed. For this reason, the cutter, when in contact with the surface of the nail, stops under the influence of resistance.

To avoid such a problem, you need to buy a handle with a high torque (above 3.5 N cm), and even better - buy it along with a powerful, improved control unit. After all, a productive pen requires a powerful control unit corresponding to it, when, in turn, a low-power unit simply technically cannot reveal its full potential. This is because units that support lower operating parameters of the handle will in no way be able to increase their values.

In other words, the handle connected to the control unit will not be able to work at its full 5 N cm and at 40000 rpm, if it supports a maximum torque of 3.5 Ncm and a rotation speed of up to 35000 rpm. In addition, a low-power control unit will not be able to provide full power to a powerful handle. Pay attention to this when choosing it!

One of the most popular, improved control units is the Marathon N7 model from Saeyang Microtech. It is this control unit that is equipped with the "Feedback" function, which just the same contributes to the stable rotation of the nozzle.

The function works as follows: when the cutter stops, the microprocessor, which is responsible for all the functions of the unit (including for feedback), adds current to the handle, as a result of which the speed is stabilized and the rotation of the nozzle resumes. This function is not available in all Saeyang control units, so the Marathon N7 model mainly stands out among all other models of this company.

This model also supports the functions of adjusting the speed of rotation and switching the direction of rotation. It is worth noting that in this case it is possible to change the direction of rotation even with the micromotor handle running at speed, although this is usually prohibited.

Marathon N7 is convenient to use not only in terms of functionality, but also due to the well-thought-out external type and small size. All main connectors, regulators and switches are located exactly on the front side of the unit, on the control panel. In most cases, some of the switches are located on the side. On top of the control unit there are several holes for installing the main working nozzles.

Again, the microprocessor is responsible for the reliability and safety of the unit: when a network overload occurs, the protection system is activated and the control unit turns off automatically. After manually turning off and on the device again, you can resume work.

It is quite natural that one of the most reliable control units is equipped with one of the most productive micromotor handles, namely the S40 handle.

This the handle boasts a really high torque of 5 Ncm and a high speed of rotation with a maximum mark of 40,000 rpm. With such parameter values, the pen can be used with confidence even for manicure, even for pedicure and podology - there will be no problems while working with it.

the diameter is only half of the diameter in the center of the handle, or rather, only 16 mm.

This kit, due to its justified reliability and performance, really deserves to be called the best router. And the high quality of components and compliance with hygiene and safety standards make it not only reliable, but also safe for use in beauty salons.